Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on Pinterest

Copper Leaf Swag

Browe Project Categories
| More

Materials:

  • 18″ Molded Swag*
  • 2 oz. pkg. Floral Moss*
  • Eight 16 1/2″ long copper bay leaf sprays, brown gold
  • Tall evergreen fern branch with approx. 6 sprigs, approx. 12″ long
  • 19″ length of iced pine needles with jingle bells
  • 2 yd. length of 1 1/2″ wide ribbon, copper
  • Tacky glue*
  • Floral pins
  • Floral cutter
  • *The following products were used for this project: FloraCraft® Molded Swag and Floral Moss, Elmer’s® Craft Bond™ Tacky Glue.
Instructions:
  1. Attach moss. Use tacky glue to attach floral moss, covering front and sides of molded swag. This serves as the base layer on the swag.
  2. Attach fern. Cut apart fern leaf sprigs into approximately 12″ lengths. Using floral pins, pin fern leaves onto swag, with stems pointed toward middle of swag. Randomly attach fern leaves.
  3. Attach bay leaves. Cut apart bay leaf sprays into three stems, approximately 6″ – 10″ long. Layer leaves from ends of swag working toward the middle and pin among fern leaves.
  4. Attach iced pine. Running vertically, insert iced pine needles into bottom middle of swag, allowing needles to hang down from swag. Secure with floral pins if needed.
  5. Attach bow. Tie ribbon into a multi-looped floral bow and attach with floral pins into center of swag.

Post a Comment

Your email is never shared. Required fields are marked *

*
*